Tower transfer trolleys need to have a good understanding of its operating procedures, especially for the first time employees, so as to avoid many problems, so as to ensure that the electric flatbed is better running, the following is Rising Lifting Xiaobian introduces some important operating procedures for everyone.

 

1. Employees who operate tower transfer flat trolleys need to be familiar with the structural performance of the equipment and can only perform independent operations after passing the test.

 

2. When transporting heavy objects, it should be smoothly placed to ensure uniform weight distribution, and equipment that cannot be over-standardized or overloaded.

 

3. When changing the running direction during use, you need to wait for the motion to stop before you can start the reverse direction.

 

4. The operating staff must also inspect the electric flatbed equipment in accordance with the relevant inspection requirements.

 

5. In addition, it is necessary to strictly follow the lubrication chart of the electric flatbed for lubrication and regular timing.

 

6. Before starting the tower transfer trolleys, you need to send a signal to see if there is no movement in the direction of movement, no obstacles can be activated, and the starting and stopping should be stable.

 

7. For battery tower transfer trolleys, when the power is insufficient, the battery should be taken out in time and charged as required, and replaced with a spare battery for use. The replacement of the battery and the charging work should be carried out by a special person.

 

8, can not start the electric flatbed to hit, drag, top, pull the vehicle on the railway.

 

9. The signs of forward and backward directions should be obvious, and the switch should be consistent and reverse. There can be no cases where the operator leaves or the person is hosted.

 

10, the operation staff should conscientiously do "four meetings" (will use, will check, will maintain, will eliminate the fault) and "three good" (use, manage, repair)

 

11. After use, you need to remove the load and cut off the power supply, and clean and clean according to the system.

 

12. Regularly check the operation of each part. If the motor or bearing temperature is too high or there is abnormal sound, it is necessary to stop in time for inspection.